Adjusting Burr Alignment HG-1 2017 Model

These instructions are for the 2017 model of the HG-1 which has alignment mechanisms that allow for user adjustments.

 

 

Planar Adjustments

HG1_v5

Using a 5mm hex key, loosen but do not remove the screws on the bottom of the burr collar shelf.

HG1_v5

Shift the burr assembly in the desired direction. Tighten the screws when satisfied. If necessary, set the grinder as close as possible to the zero-point while the screws are loose and make the necessary adjustments before tightening the screws.

Rotational Adjustments

HG1_v5

Using a 6mm hex key, loosen but do not remove the screws on the back of the grinder.

HG1_v5

Rotate the burr assembly in the desired direction. Tighten the screws when satisfied. If necessary, set the grinder as close as possible to the zero-point while the screws are loose and make the necessary adjustments before tightening the screws.

We recommend the user only preform one set of adjustments at a time, starting with the planar and then moving onto the rotational axis if necessary.